Page 1 of 1
parts needed
Posted: Sat Oct 21, 2006 10:32 pm
by LD
does any one know where i can get the back glass rubber molding? have to remove back glaass to install a new head liner/
Posted: Sun Oct 22, 2006 12:08 pm
by savvy59
LD,
Try andy bernbaum at oldmoparts.com
He shows the back glass rubber for 1959 Plmouth for $95
Remember to order the proper rubber as he shows two styles (one with fat rubbber and one with screw on garnish moulding on the inside of the glass).
I recently bought front glass rubberm from him and it was perfect for the Job.
Service was quick.
Good Luck,
Curt in MD
Posted: Sun Oct 22, 2006 8:07 pm
by batmobile
that's a good tip to have curt, i was afraid i was gonna have to use my oe. it looks pretty sad. the OK sun has taken it's toll, on the whole car. the front windshield got so hot that the plastic in the center of it burnt and melted, and there is now discoloration all the way around for like 1/2". no big, gotta replace the glass anywho, got a guy in OKC i need to talk to about it that has(or at least HAD), if i ever get a chance. j
Posted: Mon Oct 23, 2006 11:39 pm
by rogerh
that sounds like a MUCh better idea than me trying to figure out which gaskets (used) I have here. You didnt say what you needed..sedan or hardtop gasket...I know, I should know what model you have, but it does help when you post all the cogent info