The Suburban
Posted: Thu Feb 05, 2015 12:04 am
So this project started a few years ago and was going to be a quick get her back on the road in original condition project.....
It is now a frame off resto with some modifications: new rearend with 3:55 posi and A 518 overdrive tranny (727 with an overdrive).
Here are a few pics
Had a problem with the frame going to the ground after the engine was put in....Then I figured out I put the torsion bars in while the car wheels were flat on the ground...therefore no torsion..oops...So I pulled them out today and decided to make sure that I didnt mix the right and the left one... The right (passenger) said R 606 ...so I must be good....but I checked the left side anyhow and it said R 604...????????? So somewhere in the life of this wagon someone replaced the driver torsion bar or there was a serious screw up in the factory in 1959....I suspect it was the former. After discussing it with John Fowlie and looking at the parts manual I have decided that I have a torsion bar for the right for a 6 cylinder wagon (MP1) and a torsion bar for the right for a 8 cylinder wagon (MP2)..... Im glad I looked this could have been bad once this is on the road.
So thats where Im at...once the new transmission crossmember is in I will measure for the new drive shaft and this part will get put away and the body started on...May have to modify the tranny tunnel a bit due to the new overdrive but thats what a plasma cutter and welder are for.
more pics to follow.